Howdy, I'm thinking of running the ol Vee in some autocrosses and I'm wondering what size and offset of wheels are commonly used and what brand and size of tires. I'm also curious about tire pressure.
Thanks,
Bob
wheels and tires for Auto-X
-
- Posts: 293
- Joined: June 24th, 2006, 7:21 pm
Re: wheels and tires for Auto-X
The standard solo vee wheels are 13x8 front and 13x10 (or 13x9) rear, with Hoosier 20x7.5-13 front and 20x9-13 rear, R25B compound.
Offsets vary (I'm not sure what mine are), but the main factor is clearance with the suspension. I'm guessing (roughly) the offset is around 1", front and rear. The best measurement to use when ordering wheels is the backspacing. That's the distance from the wheel mounting to the inside of the wheel edge (easy to measure clearance on the car).
I run pressures between 13 and 15 psi. YMMV
I've run against vees with the full road racing setup, and they're only 2 or 3 seconds slower.
Offsets vary (I'm not sure what mine are), but the main factor is clearance with the suspension. I'm guessing (roughly) the offset is around 1", front and rear. The best measurement to use when ordering wheels is the backspacing. That's the distance from the wheel mounting to the inside of the wheel edge (easy to measure clearance on the car).
I run pressures between 13 and 15 psi. YMMV
I've run against vees with the full road racing setup, and they're only 2 or 3 seconds slower.
Re: wheels and tires for Auto-X
Ah yes, I meant backspacing. Offset is such a strange way of referencing a wheel.
I wasn't sure if the R25 compound would heat up fast enough or if you guys were using an A6.
Thanks for the info.
-Bob
I wasn't sure if the R25 compound would heat up fast enough or if you guys were using an A6.
Thanks for the info.
-Bob
Re: wheels and tires for Auto-X
If you go digging through this admittedly dated info, you'll find what tires and wheel sizes many of these Vee pilots are/were running listed with their pictures:
http://www.geocities.com/svoa2000/Pictures.htm
http://www.geocities.com/svoa2000/Pictures.htm
-
- Posts: 293
- Joined: June 24th, 2006, 7:21 pm
Re: wheels and tires for Auto-X
Isn't the A6 radial? I don't think radials would work well with vees. Too light and bizarre front suspension geometry.TigerBob wrote:I wasn't sure if the R25 compound would heat up fast enough or if you guys were using an A6.
Re: wheels and tires for Auto-X
Ahh, I didn't realize there would be much of a difference between a radial and bias ply.