I am building a new engine and hope to make some improvements over my current one (1915cc). My question to my fellow Solo Veers concerning connecting rod prep. What is our minimum connecting rod weight? FV is 425g or are we heavier? Am I allowed under the current rules to polish the rods?
Thank, Richard
Caldwell D-13
Rules Clarification
Re: Rules Clarification
The rules for SoloVee in Appendix A of the Solo rulebook specifically refer to GCR rule C.1.1.C.6 which requires a minimum rod weight of 425 grams. The GCR allows rods to be lightened. I would interpret that to mean polishing is allowed to get to 425 grams.
69 Beach Solo Vee, #65 FM
85 Lynx B Solo Vee
71 Zink C4 Solo Vee
85 Lynx B Solo Vee
71 Zink C4 Solo Vee
-
- Posts: 23
- Joined: March 24th, 2008, 2:14 pm
Re: Rules Clarification
You sure about that? I'm looking at the current GCR and it show C.6 as Transmission/Rear Axle. Section C.5 is Engine, and is excluded from the Solo rules.
I think the OP's question would be covered under Solo rules Appendix A, CM section C.2.b, balancing.
I think the OP's question would be covered under Solo rules Appendix A, CM section C.2.b, balancing.