OIL BREATHER KIT
-
- Posts: 90
- Joined: January 13th, 2011, 7:54 pm
OIL BREATHER KIT
A question for the experts in here ......Just watched a video on You tube on installing an oil breather kit from valve covers to a small oil tank...is it a good idea for FV Racing engines?
Re: OIL BREATHER KIT
Sorry - not allowed in FV. But it's probably a bad idea for FV, anyway. It's used in dune buggies and some solo people use it, I think. Since it's illegal in Vee, it isn't talked about much, but it would seem that you would be more likely to be pushing oil up INTO the heads than it draining out into the sump (or wherever) due to the high cornering loads ... through some LONG corners that we experience, that aren't seen in solo or dune buggies.
Regardless of it's viability, you can't do it in Vee and be legal.
Steve, FV80
PS - I'm not an 'expert', but I have slept at a Holiday Inn Express at times .
Regardless of it's viability, you can't do it in Vee and be legal.
Steve, FV80
PS - I'm not an 'expert', but I have slept at a Holiday Inn Express at times .
The Racer's Wedge and now a Vortech, FV80
-
- Posts: 293
- Joined: June 24th, 2006, 7:21 pm
Re: OIL BREATHER KIT
When I first bought my solo vee, it had the stock oil filler tower with a crude vent system that always filled up the catch tank after 3 runs. When I had my solo vee engine rebuilt at SR, I asked Jim about valve cover vents. He said it wasn't good for racing, and recommended replacing the stock oil filler with a different cap (they had in stock). Since then (4 years?), the oil catch can never gets more than a tablespoon of oil each season, and the valve covers never leak.
Re: OIL BREATHER KIT
Actually I think it is legal in vees since our valve covers are considered free. See C.5.D.18, " Valve covers are unrestricted and may be bolted on." The operative term is unrestricted. I have run the vents before and it can be helpful but cumbersome. If the exhaust valve guides are shot it will really pressurize the area under the valve cover and cause leaks. Vents will reduce the leakage.
The above post is for reference only and your results may vary. This post is not intended to reflect the views or opinions of SCCA and should not be considered an analysis or opinion of the rules written in the GCR.
Re: OIL BREATHER KIT
Yes, you can vent valve covers, But in a pancake engine it is a pretty bad idea. You have to vent towards the high side and then run the lines up a good several inches above your puke tank and then back down again into the tank. You will still get more oil than you would like. In long G turns way too much oil gets into the valve cover and any pressure at all blows it out those vents. Vent the case with the existing baffle arrangement and use minimum of 1/2" (-8) line. (or two). Run it up a few inches and then to the puke tank. If you are blowing more oil that you should, you have excessive case pressure (rings, etc.) or your oil level might be too high.
Re: OIL BREATHER KIT
Exacto mundo Jim. I agree 100%
The above post is for reference only and your results may vary. This post is not intended to reflect the views or opinions of SCCA and should not be considered an analysis or opinion of the rules written in the GCR.