Spindle Checking device

Post Reply
FV80
Site Admin
Posts: 1195
Joined: June 27th, 2006, 9:07 am

Spindle Checking device

Post by FV80 »

As I was checking one of my spindles yesterday, I thought I should share my 'device' info with the group - then I remembered I already did some time back (years). This morning, I decided to double check for my post and it appears that although I did build a web page for it, I never got around to actually POSTING my info. SO.. for any of you that can't quite figure out a good easy way to check for a bent spindle, here it is...
http://www.WedgeRacing.com/spindles .
This is a really cheap, but quite accurate tool that can be used with the spindle still mounted on the car. It weighs next to nothing and isn't too difficult to make, although it almost DEMANDS access to a lathe.

Works GREAT. Unfortunately, it confirmed that my spindle *IS* bent :cry:
Hope this is useful to someone out there.
Steve, FV80
The Racer's Wedge and now a Vortech, FV80
brian
Posts: 1348
Joined: June 26th, 2006, 12:31 pm

Re: Spindle Checking device

Post by brian »

Nice piece, what's the cost for making a compliment? :P
The above post is for reference only and your results may vary. This post is not intended to reflect the views or opinions of SCCA and should not be considered an analysis or opinion of the rules written in the GCR.
Rickydel
Posts: 199
Joined: July 5th, 2006, 11:09 am

Re: Spindle Checking device

Post by Rickydel »

Hmmm. For the $1000 fee paid for me to duplicate the tool, are you supplying the PVC?
Your answer will help me decide whether or not I proceed.
FV80
Site Admin
Posts: 1195
Joined: June 27th, 2006, 9:07 am

Re: Spindle Checking device

Post by FV80 »

Nope. You have to provide your own. I did say "please", so I guess that means the $1000 is optional :) ...it's worth every penny when you need it.
Steve, fv80
The Racer's Wedge and now a Vortech, FV80
Rickydel
Posts: 199
Joined: July 5th, 2006, 11:09 am

Re: Spindle Checking device

Post by Rickydel »

Fuhgetaboutit then. I'm not makin' it. :P
FV80
Site Admin
Posts: 1195
Joined: June 27th, 2006, 9:07 am

Re: Spindle Checking device

Post by FV80 »

I'll need to see the inside of your toolboxes the next time we cross paths. :)
Sd
The Racer's Wedge and now a Vortech, FV80
Post Reply