Locost project

Post Reply
bobc
Posts: 37
Joined: February 9th, 2008, 10:50 am

Locost project

Post by bobc »

I have too many projects and must get rid of my Locost car. The frame is complete to Ron Chapmans book and is of 4130 steel with a steel underpan. The doner car is a Fiat 124. The engine has new bearing, oil pump and rings. The five speed trans has new syncros. Both the engine and trans are mounted in the car on new mounts. The cams are not in as I was going to have them reground. Ther is a 4-2-1 exhaust manifold and the stock carb along with two Dellorto carbs. All of the guages along with the front disk brakes and a complete rear end. Basically almost everything you need to finish the car. It also comes with a complete Fiat 124 including title. $3000 takes it all. I will enclude the book in the deal. The car is near Nashville, Tn.
csingletary01
Posts: 73
Joined: November 29th, 2009, 2:00 pm

Re: Locost project

Post by csingletary01 »

do you have any photos?
bobc
Posts: 37
Joined: February 9th, 2008, 10:50 am

Re: Locost project

Post by bobc »

csingletary01 Check your messages
Post Reply