FORMULAVEE.ORG

Count me in for Mid Ohio. Hopefully other events as well. Dale Rader.

And don't forget cheaper. That should have them laughing unil their sides hurt!!!!

Dean Spun In Turn 5(?) on lap 2, and rick, and I got taken out. I survived with just a flat tire, and after limping into the pits, got back on track about 3 laps down, but Rick took the brunt of it. Broken transmission case, Torn off left, rear suspension pick up point, and unknown engine damage. Dale

Dave had engine problems in qualifying, and I'm told, also in the race, I went off on lap 20(?) from second place, in turn 10, and got hung up in the gravel. Rick Shields went off the same time I did, but managed to keep going. Roger, Rick, Jonathan, and I Had a pretty good race, with lots of positi...

Ours should be Arriving in the next couple of weeks. Testing will start when we can get sme private track days.

I'Ve Found both Setrab, and Mocal work very well. Dale

Set "A" (Dry Shocks) 12.75" Length, 9.75" Compressed. Valving: Compression 13/54, Rebound 13/56 With Std. 3 Deg. Dish, .020 Bleed Set "B" (Rain Shocks) 13.125" Length, 9.75 Compressed. Valving: Compression 13/54, Rebound 13/56 With 1 Deg. Dish, .040 Bleed. Either S...

Cockpit adjustable Compression, A/D Valving, Fresh rebuild, $500.00 Dale

2 Sets, Both sets Stamola valved, Both sets just rebuilt, and in good condition. $475.00 a set. Dale.

I usually don't get to involved with the politics of our sport, but I think I have to comment on the disc brake debate. First off I mst confess I would prefer disc over drum brakes. Mostly due to the lack of availability of "light" drums, and wheels. BUT I must share what i will do if disc...

Helical cut gears, generaly do not benefit very much from polishing, like straight cut gears will. The Gears want to "walk" on the shaft, away from each other, without some sort of "bite". This will cause excessive drag on the thrust bearing/washers on the end of the shafts. This...

Any Type of pollishing Is removing metal, Deburing a new gear is removing metal, Radiusing edges on axle ends is removing metal. How far do you want it to go? Just something to think about. Dale.